Car Recall Check

An oil leak from the turbocharger oil feed pipe could create slippery section on the road, creating a risk of accident for motorcycles and other two-wheeled vehicles. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

The lower A-pillar bolt on the right may not have been fastened to the body with the correct torque. In the case of plug-in hybrid vehicles (PHEVs) with 7 seats, it is possible that the body structure may not perform as intended in certain crash modes. In the event of an accident, there is an increased risk of injury to occupants of the vehicle. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

An electrical overload in the 48Volt (V) electrical system may cause a failure of the Metal Oxide Semiconductor Field Effect Transistor (MOSFET). This may cause an electrical cascade failure, causing the DCDC convertor to experience an electrical short where the 12V circuit shorts to ground. As a result, smoke from the DCDC converter can be vented into the passenger compartment, and where sufficient oxygen exists, a sustained vehicle fire may occur.

Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time.As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Activation of the driver side airbag can result in inflator rupture which may cause metal fragments to pass through the cushion material, causing injury to the occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

The pretensioner tubes might have been damaged during assembly due to a manufacturing defect of certain front seat belt pretensioners This can result in reduced or complete loss of pretension in the event of a crash and could increase the risk of injury to the occupant. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.