CITROEN C4 CACTUS UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2023/046 (652)

Manufacturer Reference

HUZ/191242CO

Defect

On the affected vehicles the operation of the brake vacuum pump may be affected by material detaching from the timing belt caused by the ageing of the engine oil.

Remedy

To rectify this issue a software update will be downloaded which will improve the vacuum diagnosis (in order to warn earlier about the risk of loss or reduction of braking assistance). The timing belt will be checked and if needed replaced with other components of the braking assistance system and the vacuum pump.

---

Recalls Number (Vehicles Effected)

R/2023/036 (13740)

Manufacturer Reference

HLX/ 191242CO

Defect

On the affected vehicles the operation of the brake vacuum pump may be affected by material detaching from the timing belt caused by the ageing of the engine oil.

Remedy

To rectify this issue a software update will be downloaded which will improve the vacuum diagnosis (in order to warn earlier about the risk of loss or reduction of braking assistance). The timing belt will be checked and if needed replaced with other components of the braking assistance system and the vacuum pump.

---

Recalls Number (Vehicles Effected)

R/2020/327 (21226)

Manufacturer Reference

HFC

Defect

The brake vacuum pump may be affected by material detaching from the timing belt.

Remedy

Update detection software inspect and if necessary replace vacuum pump and timing belt.

---

Recalls Number (Vehicles Effected)

R/2019/384 (3)

Manufacturer Reference

GZC

Defect

The fitting of the rear left brake pipe may not be correct to specification

Remedy

Check the correct fitting of the left hand brake pipe adjust or replace the pipe as necessary

---

Recalls Number (Vehicles Effected)

R/2019/137 (148)

Manufacturer Reference

GLT

Defect

A plastic component inside the exhaust line could under certain circumstances damage the diesel particle filter.

Remedy

Check and if necessary replace the particle filter.

---

Recalls Number (Vehicles Effected)

R/2017/271 (16984)

Manufacturer Reference

GBP

Defect

The striker wire on the bonnet lining may not have sufficient support to prove it with the security for its intended purpose. This can lead to incorrect locking of the bonnet over time and could result in an unintentional release of the bonnet.

Remedy

On affected vehicles inspect and if requiredfit an additional strengthener to retain the striker cable on the inner panel of the bonnet. In some cases it may be necessary to replace the bonnet.

---

Recalls Number (Vehicles Effected)

R/2017/176 (331)

Manufacturer Reference

NZL

Defect

On the affected vehicles the bonding of the front bumper trim may not conform to specification. Over time the bonding may allow the trim to detach

Remedy

Check the bonding of the front bumper lower trim and rectify or replace it if necessary

---

Recalls Number (Vehicles Effected)

R/2017/168 (8)

Manufacturer Reference

NZU

Defect

"Due to a non conformity in production an engine fuel pie protective sleeve couldcause wear due to contact with surrounding components.This may cause a fuel leak"

Remedy

"On affected vehicles reposition the fuel pipe protective sleeve or replace the pipe ifwear is noted."

---

Recalls Number (Vehicles Effected)

R/2017/139 (3607)

Manufacturer Reference

NYD

Defect

A possible nonconformity of an internal component of the starter motor relay could affect the control of the starter motor. This could adversely affect the starting operation and damage the starter motor due to overheating and in extreme cases there is a risk of fire.

Remedy

On affected vehicles check and where necessary replace the starter motor relay.

---

Recalls Number (Vehicles Effected)

R/2017/126 (16)

Manufacturer Reference

NVE

Defect

A component in the gearbox actuator may not be to the correct specification which may affect gear selection.

Remedy

On affected vehicles replace the gearbox actuator

---

Recalls Number (Vehicles Effected)

R/2016/277 (11236)

Manufacturer Reference

NTT

Defect

It has been identified that the striker wire on the bonnet lining may not have sufficient support to prove it with the security for its intended purpose. This can lead to incorrect locking of the bonnet over time and could result in an unintentional release of the bonnet. The driver will received early warning signs or symptoms by the incorrect locking of the bonnet.

Remedy

Recall all affected vehicles to inspect and if required an additional strengthener to retain the striker cable on the inner panel of the bonnet. In some cases there maybe a requirement to replace the bonnet.