CITROEN DISPATCH UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2019/436 (85)

Manufacturer Reference

HBM

Defect

The tightening of the seat belt fixings and of certain earth cables may not conform to specification.

Remedy

Tightening of the seat belt fixings and of certain earth cables

---

Recalls Number (Vehicles Effected)

R/2019/434 (84)

Manufacturer Reference

HBL

Defect

A non-conformity of the rear brake callipers could reduce the efficiency of the parking brake

Remedy

Check and if necessary replace the callipers.

---

Recalls Number (Vehicles Effected)

R/2019/437 (3111)

Manufacturer Reference

HBN

Defect

The tightening and positioning of the seat belt lower bolts may be incorrect.

Remedy

This campaign consists of checking and if necessary correcting both the position of the bolt and the tightening torque of all of the lower fixings of the seat belts.

---

Recalls Number (Vehicles Effected)

R/2019/432 (21087)

Manufacturer Reference

Defect

The fuel pipes under the body may have been damaged over time due to a relative movement between these pipes and their surroundings

Remedy

Check the condition of the fuel pipes and replacing them if necessary. New protection will be fitted on all vehicles to prevent this damage in the future.

---

Recalls Number (Vehicles Effected)

R/2020/077 (4)

Manufacturer Reference

HBA

Defect

The tightening of some rear suspension fixings may not be correct to specification

Remedy

Correcting some tightening torques and replacing some nuts and bolts.

---

Recalls Number (Vehicles Effected)

R/2020/069 (84)

Manufacturer Reference

HBT

Defect

Possible non-conformity of certain seals in the front wheel arches could lead to water ingress into the passenger compartment.

Remedy

Resealing these areas checking for the presence of water in the passenger compartment and replacing certain components in the interior if required

---

Recalls Number (Vehicles Effected)

R/2017/070 (141)

Manufacturer Reference

NXB

Defect

It has been identified that due to a possible non-conformity of certain seals on the vehicle?s body there is the possibility that water can enter the passenger compartment of the vehicle. The occupants should experience either wet carpets and or a possible damp smell. However the ingress of water into the cabin could affect the electrical operation of the airbag module which could lead to an unexpected deployment of the airbag.

Remedy

Recall all affected vehicles to add additional sealant to the body interfaces and if required to replace any interior components damaged by the water ingress.

---

Recalls Number (Vehicles Effected)

R/2017/065 (8)

Manufacturer Reference

NYG

Defect

It has been identified that some ground connections of the cabin wiring harness and the fixings of the airbag control unit may not be to specification. This issue or non-compliance could cause erratic malfunctions of certain electrical equipment even in very rare cases causing the engine to cut-off or airbags malfunction.

Remedy

Recall all affected vehicles to check tightness of the ground connections and airbag control unit fixings. If required these will need rectification.

---

Recalls Number (Vehicles Effected)

R/2017/060 (1653)

Manufacturer Reference

NYM

Defect

On the affected vehicles a possible nonconformity of certain seals on the vehicle?s body could lead to water ingress in the passenger compartment. This may affect the operation of the passenger air bag. Unintended deployment is possible.

Remedy

On affected vehicles add extra sealant and replace wet or water damaged components.

---

Recalls Number (Vehicles Effected)

R/2017/071 (2)

Manufacturer Reference

NYH

Defect

Incorrect assembly of the steering rack which could cause the loss of the mechanical link between the steering pinion valve and the steering rack during parking manoeuvres at full lock.

Remedy

Check affected vehicles and where necessary replace the steering rack.

---

Recalls Number (Vehicles Effected)

R/2010/223 (20089)

Manufacturer Reference

MGG

Defect

In very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.

Remedy

Recall the vehicles that are likely to be affected to replace the brake vacuum pump one way valve.

---

Recalls Number (Vehicles Effected)

R/2010/111 (630)

Manufacturer Reference

MFZ

Defect

The threaded portion of the brake linkage rod in the brake control system may not be to conformity. This could result in a reduction of braking efficiency.

Remedy

Recall affected vehicles to check rod and replace if found not to meet conformity.

---

Recalls Number (Vehicles Effected)

R/2010/030 (2258)

Manufacturer Reference

MDM

Defect

It has been identified that water may ingress the brake drums causing premature brake lining wear. Should this occur the brake effort produced by the rear wheels may be reduced.

Remedy

Recalled vehicles will have a seal fitted to the handbrake cable and the subject brake linings replaced.

---

Recalls Number (Vehicles Effected)

R/2010/019 (1135)

Manufacturer Reference

MDP

Defect

It has been identified that the possibility exists that contact between the fuel return pipe and the engine shield may take place inside the engine compartment. Should this occur wear on the pipe would ensue which in the worst case; would result in a fuel leak.

Remedy

Recalled vehicles will be fitted with an additional fastener to ensure that contact is not made and if necessary the fuel return pipe will be replaced.

---

Recalls Number (Vehicles Effected)

R/2009/113 (37086)

Manufacturer Reference

MBT

Defect

It has been identified that due to incorrect positioning of the exterior lighting control ring by the lighting management system the lights may switch off unexpectedly.

Remedy

Recalled vehicles will have the lighting management software updated

---

Recalls Number (Vehicles Effected)

R/2008/197 (178)

Manufacturer Reference

MAN

Defect

It has been identified that on affected vehicles a non conformity within the accelerator pedal assembly may cause interference and prevent the pedal from returning to its original position. This may result in the vehicle maintaining a degree of acceleration which can be overcome by firm braking.

Remedy

Recalled vehicles will have the accelerator pedal changed.

---

Recalls Number (Vehicles Effected)

R/2007/163 (689)

Manufacturer Reference

YCW

Defect

It has been identified that poor protection of the power steering pump earth terminal; could result in loss of power assistance to the steering.

Remedy

Recalled vehicles will have the power steering pump earth terminal protection reinforced.

---

Recalls Number (Vehicles Effected)

R/2006/080 (39)

Manufacturer Reference

XYA

Defect

The seat belt locking action may not be as fast as it is designed to be.

Remedy

Recall the vehicles that may be affecte check the date of manufacture of the seat belts and where necessary replace the seat belts.

---

Recalls Number (Vehicles Effected)

R/2003/115 (266)

Manufacturer Reference

XPZ

Defect

An inadequate weld on the bottom engine mounting tie bar may fail and cause a serious engine vibration and separation of one of the driveshafts.

Remedy

Fit a replacement bottom engine mounting tie bar.

---

Recalls Number (Vehicles Effected)

R/2002/010 (80)

Manufacturer Reference

XHT

Defect

Water ingress into the underbonnet vacuum electrovalves may cause a reduction in power assistance at the brake pedal. Malfunction of the electrovalves could also adversely affect the engine exhaust emissions.

Remedy

Replace the three electrovalves as a precaution and install a protective shield over them.

---

Recalls Number (Vehicles Effected)

R/2000/122 (2812)

Manufacturer Reference

XDP

Defect

Possibility of failure of the vacuum pump drive dog leading to a loss of brake assistance.

Remedy

Recall the potentially affected range of vehicles and replace the drive dog on those equipped with a Magneti Marelli Vacuum pump

---

Recalls Number (Vehicles Effected)

R/1998/092 (689)

Manufacturer Reference

Defect

Premature wear of the handbrake ratchet pawl may lead to inadvertent release of the handbrake. Problem of material hardness discovered in Quality Control tests.

Remedy

All vehicles from the period of production that may have a defective lever to be recalled and a new lever fitted.