Date From | Date To | Concern |
---|
26/04/08 | | Raised: 01/10/13 - INABILITY TO CHANGE GEAR View/hide..
Recalls Number (Vehicles Effected)R/2013/106 (809)
Manufacturer ReferenceNemo
DefectOver time partial wear of the gearbox control harnesses may occur due to contact with surrounding components. Gear selection may be affected as a result of electrical faults in some rare cases including the lighting of the warning lamp on the instrument panel and the driveability of the vehicle may be compromised.
RemedyRecall the vehicles that are likely to be affected to check the condition of the gearbox control harness and where necessary fit additional protection.
|
26/06/12 | | Raised: 15/01/13 - BRAKING ASSISTANCE MAY BE REDUCED View/hide..
Recalls Number (Vehicles Effected)R/2013/002 (618)
Manufacturer ReferenceMTQ
DefectOne of the vacuum hose unions in the braking system may not be to specification. This could cause a reduction in braking assistance.
RemedyCheck and if necessary replace the hose.
|
26/05/10 | | Raised: 14/11/12 - ENGINE MAY FAIL View/hide..
Recalls Number (Vehicles Effected)R/2012/129 (1169)
Manufacturer ReferenceMQM
DefectIt has been established that the con-rod (big end) shell bearings may not have been manufactured to specification. This could lead to premature deterioration of the shells and if not identified it could result in engine failure.
RemedyRecall affected vehicles and replace con-rod shell bearings.
|
18/12/08 | | Raised: 22/10/12 - REAR CROSS MEMBER MAY CRACK View/hide..
Recalls Number (Vehicles Effected)R/2012/099 (4350)
Manufacturer ReferenceMNH
DefectOver a period of time a small crack can appear on the rear axle cross member particularly under conditions of repeated maximum suspension travel. The small crack could increase in size and eventually lead to the rear wheel rubbing on the wheel arch.
RemedyReplace the rear axle cross member and suspension bump stops.
|
10/05/10 | | Raised: 05/11/10 - ENGINE MAY FAIL View/hide..
Recalls Number (Vehicles Effected)R/2010/192 (72)
Manufacturer ReferenceMHB
DefectDue to incorrect machining it is possible that the crankshaft is not to the correct specification which can lead to insufficient lubrication of the crankshaft and subsequent engine failure.
RemedyRecall all affected vehicles and replace the engine.
|