MAZDA 5 UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2013/035 (1031)

Manufacturer Reference

AD004C

Defect

Water may enter the glow plug control module due to poor sealing of the waterproof connecter for the front harness. In some cases the glow plug control module could get corroded due to the water ingress and in the worst case there is a possibility that the glow plug control module could melt resulting in a vehicle fire.

Remedy

A Mazda dealer will inspect the glow plug control module and if necessary replace the glow plug control module. Also the installation location of the glow plug control module will be changed to prevent future water ingress.

---

Recalls Number (Vehicles Effected)

R/2010/217 (1518)

Manufacturer Reference

Defect

It is possible that due to cleaning process of the fuel tank water may have built up between the fuel pump and wiring harness connectors which can cause corrosion of the connector pins. In the extreme cases corrosion could result in an inoperative fuel pump which could cause the engine to stall or the inability to start.

Remedy

Recall all affected vehicles and inspect the connectors for corrosion. If corrosion or damage is found a short section of the wiring harness and fuel pump top section will be replaced.

---

Recalls Number (Vehicles Effected)

R/2008/194 (15854)

Manufacturer Reference

Defect

It is possible that white smoke can occur from the exhaust pipe and engine speed may increase whilst driving.

Remedy

Recall affected vehicles and replace Power Control Module.

---

Recalls Number (Vehicles Effected)

R/2008/050 (3965)

Manufacturer Reference

Defect

It has been identified that the number 4 engine mounting bolt may not have been tightened to the correct torque during production. This could result in the engine mounting failing under sudden acceleration.

Remedy

Recalled vehicles will have the mounting bolt checked for compliance. Should the torque on the subject bolt be found to be outside of the specification.The appropriate action as described in the technical instruction will be applied as necessary.

---

Recalls Number (Vehicles Effected)

R/2006/098 (2005)

Manufacturer Reference

Defect

It is possible for the camshaft sensor plate mounting bolts to loosen. If the vehicle continues to be used in this condition the sensor plate and bolts may fall off resulting in an engine stall and inability to restart.

Remedy

Recall the vehicles that are likely to be affected and tighten the sensor plate to the specified torque. Only replace parts if they are seen to be damaged.