MITSUBISHI SHOGUN UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2020/147 (1424)

Manufacturer Reference

Defect

The right front lower arm assembly could be broken due to improper welding by the supplier.

Remedy

The right front lower arm will be replaced

---

Recalls Number (Vehicles Effected)

R/2015/004 (11398)

Manufacturer Reference

Defect

Due to a high carbon build up the check ball seat of the timing chain tensioner can show premature wear. It is possible that the check ball may stick to the seat preventing the tensioner from functioning properly. This in turn will result in an un-tensioned timing chain which causes a rattling noise and in the worst cases the chain will break.

Remedy

Replace tensioner on all affected vehicles. Depending on outcome of further inspections the timing chain may also need to be replaced.

---

Recalls Number (Vehicles Effected)

R/2015/004 (11398)

Manufacturer Reference

Defect

Due to a high carbon build up the check ball seat of the timing chain tensioner can show premature wear. It is possible that the check ball may stick to the seat preventing the tensioner from functioning properly. This in turn will result in an un-tensioned timing chain which causes a rattling noise and in the worst cases the chain will break.

Remedy

Replace tensioner on all affected vehicles. Depending on outcome of further inspections the timing chain may also need to be replaced.

---

Recalls Number (Vehicles Effected)

R/2015/003 (2846)

Manufacturer Reference

R3027210 R3027230 R3027231

Defect

Due to a fault in the engine ECU software it is possible that the 4M41 engines in the Shogun will not learn the variations or age deterioration in injectors and be able to adjust the amount of fuel being injection accordingly. This inability to learn these values correctly can result in the engine emits an excessive amount of soot to the DPF which can block it. This can result in the engine stalling and not being able to restart.

Remedy

Recall all affected vehicles and reprogramme engine ECU software.

---

Recalls Number (Vehicles Effected)

R/2015/003 (2846)

Manufacturer Reference

R3027210 R3027230 R3027231

Defect

Due to a fault in the engine ECU software it is possible that the 4M41 engines in the Shogun will not learn the variations or age deterioration in injectors and be able to adjust the amount of fuel being injection accordingly. This inability to learn these values correctly can result in the engine emits an excessive amount of soot to the DPF which can block it. This can result in the engine stalling and not being able to restart.

Remedy

Recall all affected vehicles and reprogramme engine ECU software.

---

Recalls Number (Vehicles Effected)

R/2008/191 (10034)

Manufacturer Reference

R3016112

Defect

Due to an incorrect manufacturing process the resin film within the brake assist accumulator may become damaged. If use continues in this condition a crack in the diaphragm may occur resulting in the depletion of the nitrogen gas resulting in (1) delay of the brake assist function under rapid braking. (2) An increase in the required brake pedal effort when the engine is started following a long period with the engine stopped.

Remedy

Recalled vehicles will have the accumulator checked to identify whether or not it is one within the affected batch. Should this be the case the accumulator will be replaced with one of a modified type.

---

Recalls Number (Vehicles Effected)

R/2008/004 (26)

Manufacturer Reference

Defect

The front and rear propeller shafts and the right hand front drive shaft have been fitted with nuts of an incorrect specification. The concern could lead to vibration which if not attended to could lead to the detachment of a shaft and loss of drive.

Remedy

Recall the vehicles that are likely to be affected to replace the nuts and washers fitted to the front and rear propeller shafts and the right hand front drive shaft.

---

Recalls Number (Vehicles Effected)

R/2007/103 (726)

Manufacturer Reference

Defect

It has been identified that the possibility exists that a bolt welded to the gearshift lever may fracture. Should this occur the adjustment may loosen and the shift cable may move. This can result in a mismatch between the gear shift selector and the actual gear selected. In the worst case the bolt may break which can cause the control cable to become disconnected and drive to be lost.

Remedy

Affected vehicles will have the transmission shift lever replaced with a quality assured item.

---

Recalls Number (Vehicles Effected)

R/2007/074 (2894)

Manufacturer Reference

Defect

When used regularly in severe off road conditions the ball joint of the pitman arm may break resulting in loss of steering control.

Remedy

Recalled vehicles will be fitted with a modified pitman arm if this has not already been accomplished following a previous intervention.

---

Recalls Number (Vehicles Effected)

R/2003/163 (697)

Manufacturer Reference

Defect

There is a possibility that due to improper operation when assembling the engine at production a crack occurred on the advance control lever of the cold start device on the injection pump.

Remedy

During specific vehicle usage there is a possibility that the engine rpm could increase if the cold start lever broke.

---

Recalls Number (Vehicles Effected)

R/2001/158 (50846)

Manufacturer Reference

Defect

Under severe and extreme conditions where the vehicle is used mainly off-road in a wet muddy environment it is possible that the tapered section of the ball pin on the steering Pitman arm may break. This in the worst case could result in a loss of steering control.

Remedy

Recall the affected vehicles and replace the Pitman arm with a quality assured component.

---

Recalls Number (Vehicles Effected)

R/2001/129 (4319)

Manufacturer Reference

Defect

There is a possibility that the accumulator diaphragm in the Hydraulic Brake Booster (HBB) might be manufactured improperly. This may cause the nitrogen pressure in the accumulator to drop. The following two symptoms may result :- 1) The brake assist might be delayed in sudden hard braking. 2) Relatively large brake pedal loads might be required after long-term parking and first engine start since specific brake pressure takes time to accumulate.

Remedy

The Hydraulic Brake Booster nitrogen accumulator will be replaced with a modified one on all affected vehicles.

---

Recalls Number (Vehicles Effected)

R/2000/079 (286)

Manufacturer Reference

Defect

Brake fluid may seep from the front flexible brake hoses impairing the efficiency of one or both braking circuits.

Remedy

Recall the affected vehicles for replacement of both front flexible brake hoses.