NISSAN JUKE UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2023/096 (3157)

Manufacturer Reference

PG3C1

Defect

A potential concern affecting the HEVC (Hybrid Electric Vehicle Control) module software has been identified which may cause a module reset of affected vehicles. Simultaneous pressing of brake and accelerator could cause engine stumble or stall.

Remedy

Update the HEVC module software

---

Recalls Number (Vehicles Effected)

R/2021/345 (13569)

Manufacturer Reference

PG1CE

Defect

The rear seat back may not be securely latched when returned to the upright position after folding.

Remedy

Replace both rear seat lock knobs with a countermeasure part.

---

Recalls Number (Vehicles Effected)

R/2021/074 (7095)

Manufacturer Reference

PG1C5 PS1C0

Defect

The drivers? bag may tear during inflation.

Remedy

Replace the drivers? airbag of all potentially affected vehicles.

---

Recalls Number (Vehicles Effected)

R/2020/220 (299631)

Manufacturer Reference

PS0C1 PG0C4

Defect

Possible reduced retention force of the Rear Door Child Lock switch.

Remedy

Fit a countermeasure part into the child lock door switch aperture of all potentially affected vehicles.

---

Recalls Number (Vehicles Effected)

R/2018/233 (1046)

Manufacturer Reference

PG8BH

Defect

Ignition Switch spring defect may cause engine to be turned off while driving

Remedy

Inspect and where necessary replace the Ignition Switch

---

Recalls Number (Vehicles Effected)

R/2016/157 (7393)

Manufacturer Reference

A36/C13/F15/J11/T32

Defect

If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving depending on driving/vehicle characteristics.

Remedy

Reprogram the ECU to display a warning if the rear oxygen sensor fails.

---

Recalls Number (Vehicles Effected)

R/2015/133 (10248)

Manufacturer Reference

R1511

Defect

On affected models with a push start ignition switch the switch may remain in the pressed position and not return after switching the engine on. If the vehicle continues to be driven in this condition the emergency engine stop function may operate and cause the engine to unintentionally stop.

Remedy

Inspect and where necessary modify the push start switch housing.

---

Recalls Number (Vehicles Effected)

R/2014/167 (3489)

Manufacturer Reference

R1417

Defect

On affected vehicles the fuel pressure sensor may not have been tightened to the correct specification. Heat and engine vibration may cause the sensor to loosen and in extreme cases allow fuel to leak.

Remedy

Tighten fuel pressure sensor on affected vehicles

---

Recalls Number (Vehicles Effected)

R/2013/019 (2498)

Manufacturer Reference

PG3B1

Defect

In the event that the driver airbag is deployed during a frontal impact small holes may occur on the surface of the airbag. The holes are caused by high temperature gases from the airbag inflator exhausting directly onto the surface of the airbag material. The high temperature gas/airbag material may contact the drivers skin. The deployment performance of the driver airbag is not affected.

Remedy

To replace the driver airbag with new.

---

Recalls Number (Vehicles Effected)

R/2012/024 (4690)

Manufacturer Reference

R1201/R1202

Defect

Nissan has identified that the fuel rail pressure sensor of some vehicles may have not been correctly tightened to the fuel rail of the engine and may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition in extreme cases fuel leakage may occur.

Remedy

Re-tighten the pressure sensor and replace the pressure sensor gasket if required.

---

Recalls Number (Vehicles Effected)

R/2011/166 (2741)

Manufacturer Reference

R1114

Defect

The Turbocharger boost sensor bracket may separate from the air inlet tube. This means the boost pressure may be measured incorrectly and the engine warning lamp may be illuminated. During low-speed driving this could cause the engine to stall and not restart

Remedy

Inspect and if necessary replace the air inlet tube with a new one

---

Recalls Number (Vehicles Effected)

R/2010/226 (69)

Manufacturer Reference

PGOBA

Defect

It is possible that the vehicles brake fluid maybe contaminated with mineral oil. This can cause the seals within the system to swell and affect their sealing properties. This may require drivers to apply additional force to the foot brake and could increase stopping distances.

Remedy

Recall affected vehicles to have the system flushed and replenished with clean fluid.