Date From | Date To | Concern |
---|
15/12/06 | | Raised: 16/12/10 - BRAKING ASSISTANCE MAY NOT PERFORM CORRECTLY View/hide..
Recalls Number (Vehicles Effected)R/2010/222 (24220)
Manufacturer ReferenceYWY
DefectIn very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.
RemedyRecall the vehicles that are likely to be affected to replace the brake vacuum pump one way valve.
|
01/03/04 | | Raised: 29/10/09 - BRAKE PERFORMANCE MAY BE AFFECTED. View/hide..
Recalls Number (Vehicles Effected)R/2009/120 (1186)
Manufacturer Reference
DefectResidual low pressure persists in the power braking vacuum circuit which may result in the loss of power assistance when braking
RemedyRecall affected vehicles to fit a calibrated air vent in the vacuum circuit.
|
| | Raised: 16/07/08 - DIESEL FUEL RETURN PIPE MAY ABRADE AND WEAR. View/hide..
Recalls Number (Vehicles Effected)R/2008/106 (2323)
Manufacturer Referenceynu
DefectIt has been identified that a slight amount of play in the diesel fuel return pipe mountings on certain vehicles may over time lead to abrasion and wear of the pipe.
RemedyRecalled vehicles will have the subject clips checked and the pipe secured.
|
01/07/05 | | Raised: 01/02/08 - REDUCED BRAKING PERFORMANCE View/hide..
Recalls Number (Vehicles Effected)R/2008/015 (19867)
Manufacturer ReferenceYNMYNLYMKYMJYKLYFQ
DefectIt has been identified that on the specified vehicles a fault may develop with the brake vacuum pump. This can result in hardening of the brake pedal with an attendant loss of braking efficiency.
RemedyRecalled vehicles will have the vacuum pump replaced.
|
| | Raised: 02/06/06 - ENGINE MAY STALL View/hide..
Recalls Number (Vehicles Effected)R/2006/104 (635)
Manufacturer ReferenceYBK
DefectIt is possible that the engine may stall when lifting your foot off of the accelerator immediately after high speed usage of the vehicle.
RemedyRecall the vehicles that are likely to be affected to download a new piece of software to the engine ECU.
|
| | Raised: 23/02/06 - FUEL MAY LEAK View/hide..
Recalls Number (Vehicles Effected)R/2006/041 (4338)
Manufacturer ReferenceX9D
DefectDue to a potential fault in the engine management system an internal engine fuel leak via the injectors may occur following switching off. This would result in the engine failing to restart due to excess fuel being present in the inlet manifold or cylinders.
RemedyTo address the issue recalled vehicles will receive an engine management download.
|
31/08/04 | | Raised: 22/12/05 - AIRBAG MAY NOT DEPLOY AS DESIGNED View/hide..
Recalls Number (Vehicles Effected)R/2006/009 (20)
Manufacturer ReferenceX9K
DefectIncorrect manufacture of the rear bench seat bolsters could in the case of an impact hinder the deployment of the rear lateral airbags.
RemedyRecall the vehicles that are likely to be affected and fit modified seat bolsters.
|
| | Raised: 19/12/03 - POSSIBLE DEFORMATION OF REAR SUSPENSION View/hide..
Recalls Number (Vehicles Effected)R/2003/184 (594)
Manufacturer ReferenceX1L
DefectPossible non-conformity of the rear suspension triangles could in rare cases of stress lead to their deformation.
RemedyFit new right and left side lower suspension triangles.
|
| | Raised: 19/12/03 - PROTECTION OF THE BATTERY SUPPLY CIRCUIT. View/hide..
Recalls Number (Vehicles Effected)R/2003/183 (3696)
Manufacturer ReferenceXYV
DefectIt is necessary to protect the battery supply circuit to prevent any possible risk of an electrical short circuit
RemedyFit a replacement battery negative cable fitted with a maxi fuse also fit protective felt to the aluminium section of the air conditioning pipes to insulate them from the battery positive cable.
|
| | Raised: 26/04/02 - FRONT RIGHT HAND LOWER SUSPENSION ARM MAY NOT BE TO SPECIFICATION View/hide..
Recalls Number (Vehicles Effected)R/2002/147 (79)
Manufacturer ReferenceXWS
DefectThe front right hand lower suspension arm may not be to specification. As a consequence it may deform under certain impact loads.
RemedyCheck the identification markings on the suspension arm and replace where necessary.
|