Date From | Date To | Concern |
---|
04/09/19 | | Raised: 28/01/20 - INADEQUATE TIGHTENING OF THE REAR HUB NUTS AND POTENTIALLY THE CALIPER FIXING SCREWS ON THE LEFT AND RIGHT SIDE View/hide..
Recalls Number (Vehicles Effected)R/2020/014 (50)
Manufacturer Reference0D8L
DefectInadequate tightening of the rear hub nuts and potentially of the calliper fixing screws on the left and right side
Remedy"Check the torque of the fixing screws hub nuts and if required replace the screws bolts andthe calliper."
|
05/12/18 | | Raised: 03/09/19 - THE STOP & START FUNCTION DOES NOT PERFORM CORRECTLY View/hide..
Recalls Number (Vehicles Effected)R/2019/274 (570)
Manufacturer Reference0D3M
DefectThe STOP&START function does not perform correctly.
RemedyAn update to the Power and Switching Unit software is required
|
20/02/18 | | Raised: 04/12/18 - INCORRECT WELDING OF THE CATALYTIC CONVERTOR View/hide..
Recalls Number (Vehicles Effected)R/2018/325 (1)
Manufacturer Reference0CW2
DefectIncorrect welding of the catalytic convertor.
RemedyCheck the welding of the catalytic converter and replace it if necessary.
|
08/11/16 | | Raised: 28/03/17 - STEERING COLUMN HOUSING MAY CRACK View/hide..
Recalls Number (Vehicles Effected)R/2017/110 (7)
Manufacturer ReferenceOCHF
DefectThe steering column housing may crack making the steering wheel adjustment not as expected and/or some control arms may become difficult to use them (indicators headlight control wipers).
RemedyRecall the vehicles that are likely to be affected and replace the upper steering column complete with housing and associated fixings.
|
23/11/15 | | Raised: 31/05/16 - REAR LEFT HAND SEAT BELT MOUNTING MAY FAIL View/hide..
Recalls Number (Vehicles Effected)R/2016/114 (3)
Manufacturer Reference0CAD
DefectThe near side rear seat belt upper mounting bolt may not have been tightened to the correct specification. In the event of an accident the belt may be insecure and not act as intended.
RemedyOn affected vehicles tighten bolt to correct specification
|
01/09/09 | | Raised: 22/04/16 - BENCH SEAT MAY MOVE FORWARD WITHOUT WARNING View/hide..
Recalls Number (Vehicles Effected)R/2016/016 (194)
Manufacturer ReferenceOC4F
DefectThe beach seat base mounting screws may break when the bench is repeatedly repositioned to allow a flat load area. Should this happen a noise will be heard from the bench. In exceptional cases if the screw has broken this may cause a loss of protection during an impact.
RemedyRecall the vehicles that are likely to be affected and inspect the vehicle. A metal insert will be fitted between the seatback folding pivot and the mounting screw (left and right). Additionally the mounting screws (left and right) will also be replaced.
|
01/10/12 | | Raised: 28/08/14 - BRAKING EFFICIENCY MAY BE AFFECTED View/hide..
Recalls Number (Vehicles Effected)R/2014/096 (772)
Manufacturer ReferenceOBX3
DefectBrake pipes fitted to the ABS unit may not have been fitted to the correct port. During heavy braking conditions this may cause under braking. It is also possible that the ESP may malfunction/fail to work which may cause under/over steer.
RemedyAffected vehicles will be recalled to check brake pipes are fitted correctly to the ABS unit. Where necessary the brake pipes will be replaced.
|
| | Raised: 28/06/13 - FUEL PIPE PROTECTIVE COVER MAY DETACH & DAMAGE ENGINE View/hide..
Recalls Number (Vehicles Effected)R/2013/073 (2496)
Manufacturer Reference0BMX
DefectThe fuel pipe protective cover may fail and damage the engine. In the worst case the engine could cease to function.
RemedyRecall the vehicles that are likely to be affected to replace the fuel pipe protective cover with a modified type.
|
| | Raised: 17/01/12 - SEATBELT MAY FAIL View/hide..
Recalls Number (Vehicles Effected)R/2012/002 (2243)
Manufacturer ReferenceOBDL
DefectThere is a possible issue with the security of the lower seat belt mounting bolt which could cause it to loosen. If this were to occur then the bolt could ultimately fully unwind and detach. This could result in the occupant not being restrained by the seat belt in the event of a collision.
RemedyRecall all affected vehicles and replace the lower seat belt mounting bolts.
|
01/04/09 | | Raised: 22/06/10 - BRAKING EFFICIENCY MAY BE AFFECTED View/hide..
Recalls Number (Vehicles Effected)R/2010/023 (149)
Manufacturer ReferenceOB76
DefectIt has been identified that the possibility exists that the front brakes hoses may become disconnected resulting in a loss of brake hydraulic fluid and a reduction in braking efficiency.
RemedyRecalled vehicles will have both front brake hoses replaced.
|
| | Raised: 27/10/09 - POSSIBLE LOSS OF POWER ASSISTANCE TO THE STEERING View/hide..
Recalls Number (Vehicles Effected)R/2009/116 (34403)
Manufacturer ReferenceOB1E
DefectPower assistance to the steering might be lost because of a problem in the software.
RemedyRecall the vehicles that are likely to be affected to reprogramme the ECU.
|
23/05/01 | | Raised: 10/01/02 - DOOR SECURITY CONCERN View/hide..
Recalls Number (Vehicles Effected)R/2001/161 (1445)
Manufacturer Reference0A53
DefectCustomers may find that they are unable to secure the front and side doors of their vehicles due to wear of the locking bolt due to omission of heat treatment.
RemedyRectified by replacing both the front and side door locks.
|
23/12/98 | | Raised: 26/01/01 - UNINTENTIONAL DEPLOYMENT OF AIR BAGS AND/OR SEAT BELT PRE-TENSIONERS View/hide..
Recalls Number (Vehicles Effected)R/2000/137 (14046)
Manufacturer Reference0A02
DefectA fault within the control unit may cause unintentional deployment of the front air bags and or seat belt pre-tensioners.
RemedyRecall affected vehicles and fit a quality assured control unit.
|
23/12/98 | | Raised: 26/01/01 - UNINTENTIONAL DEPLOYMENT OF AIR BAGS AND/OR SEAT BELT PRE-TENSIONERS View/hide..
Recalls Number (Vehicles Effected)R/2000/136 (14046)
Manufacturer Reference0A02
DefectA fault within the control unit may cause unintentional deployment of the front air bags and/or seat belt pre-tensioners.
RemedyRecall affected vehicles and fit a quality assured control unit.
|
01/04/00 | | Raised: 15/12/00 - RISK OF RAPID LOSS OF TYRE PRESSURE View/hide..
Recalls Number (Vehicles Effected)R/2000/103 (969)
Manufacturer Reference0A2L
DefectThere is a possibility of a rapid loss of tyre pressure on Kleber C100 165/70 R14 85 R tyres due to low inner rubber thickness on casing ply cord in tyre shoulder zone. This may affect the vehicle's road holding.
RemedyRecall affected vehicle's and replace tyres with quality assured tyre.
|