RENAULT MASTER UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2024/148 (90)

Manufacturer Reference

0EAY

Defect

On affected vehicles there is a potential risk the electrical powertrain may not be secured correctly.

Remedy

Check and change the electric traction reducer mounting if necessary.

---

Recalls Number (Vehicles Effected)

R/2020/119 (134)

Manufacturer Reference

0DAH

Defect

Due to the incorrect calibration of the injection computer the fixed speed limiter is inoperative.

Remedy

Re-program the injection computer.

---

Recalls Number (Vehicles Effected)

R/2018/143 (379)

Manufacturer Reference

0CR5

Defect

No warning light on the dashboard should the power steering fail

Remedy

Re-programme dashboard computer

---

Recalls Number (Vehicles Effected)

R/2018/079 (124)

Manufacturer Reference

0CTQ

Defect

The Steering column may become detached from the rack due to incorrectly tightened bolt.

Remedy

"On affected vehicles check for presence of retaining nut. If present tighten nut to specified torque. If nut is absent replace bolt and screw and tighten to specified torque.THE MANUFACTURER HAS ADVISED NOT TO DRIVE THE VEHICLE"

---

Recalls Number (Vehicles Effected)

R/2017/014 (324)

Manufacturer Reference

OC4M

Defect

It has been identified that the side board hinges may fail. This could result in the detachment of the side board whilst the vehicle is in motion.

Remedy

Recall all affected vehicles to install safety reinforcement brackets to the side raves of the body.

---

Recalls Number (Vehicles Effected)

R/2016/108 (55)

Manufacturer Reference

0C6R

Defect

On affected vehicles the turbocharger induction pipe may fail allowing oil to leak. Vehicle users may notice a drop in oil level which should also cause the oil warning lamp to illuminate. This may lead to engine failure and In extreme cases a risk of fire.

Remedy

On affected vehicles replace the turbocharger oil induction pipe.

---

Recalls Number (Vehicles Effected)

R/2016/001 (527)

Manufacturer Reference

0C68

Defect

On affected vehicles the drive to brake vacuum pump may fail. This may cause a loss of brake servo assistance and a hard brake pedal. It may also cause a reduction in engine power.

Remedy

Check the manufacture date of the vacuum pump and where necessary replace the pump.

---

Recalls Number (Vehicles Effected)

R/2014/042 (1145)

Manufacturer Reference

OBTY

Defect

The prop shaft to axle flange bolts may not be tightened to the correct torque. The condition could develop noise and vibration and if not corrected loss of drive.

Remedy

Recall the vehicles that are likely to be affected to either re torque the prop shaft to axle flange mounting bolts or where necessary replace the nuts and bolts and apply the correct torque.

---

Recalls Number (Vehicles Effected)

R/2011/102 (218)

Manufacturer Reference

OBDH

Defect

It is possible that the rear wheel bearing has been damaged whilst it was assembled onto the stub axle. This should be identified by excessive noise however in the worst case if not detected it could result in bearing failure and the detachment of the wheel and hub.

Remedy

Recall all the affected vehicles and replace the wheel bearings with new items which will have protective sleeves to aid correct installation.

---

Recalls Number (Vehicles Effected)

R/2011/074 (1318)

Manufacturer Reference

OBAQ

Defect

The spare wheel carrier winch system may allow the spare wheel to be loosely installed after the customer has used the winch. In this condition the spare wheel might move during driving which may damage and eventually break the cable and guiding pin of the winch system. In this worst case the spare wheel would become detached from the vehicle.

Remedy

Recall the vehicles that are likely to be affected to replace the complete spare wheel winch system.

---

Recalls Number (Vehicles Effected)

R/2010/167 (228)

Manufacturer Reference

ob9t

Defect

There is a risk that the nearside rear axle spindle may crack which in the most serious cases will lead to the spindle breaking which dependent on loading could make directional control difficult to maintain.

Remedy

Recall the vehicles that are likely to be affected to change the rear axle.

---

Recalls Number (Vehicles Effected)

R/2010/168 (965)

Manufacturer Reference

OB9T

Defect

It has been found that some of the front seat mounting brackets have not been correctly fitted to the seats. The front seat mountings could fail if the fitting brackets have been incorrectly fitted. Vehicle control could be affected.

Remedy

Recall the vehicles that are likely to be affected to check and where necessary fit new seat assemblies.

---

Recalls Number (Vehicles Effected)

R/2009/137 (4591)

Manufacturer Reference

OB5L

Defect

Due to the non-conformity of some welds under situations of extreme braking the driver's seat may detach from the floor fixing.

Remedy

Recalled vehicles will have the subject welds and fixing lugs re-welded.

---

Recalls Number (Vehicles Effected)

R/2006/123 (1023)

Manufacturer Reference

oalu

Defect

It is possible that the rear caliper handbrake lever to crack and weaken. In the worst case there is a possibility that the parking brake cables will release.

Remedy

Recall the vehicles that are likely to be affected and check the caliper handbrake lever for evidence of a crack. Where a crack exists on the lever the caliper will be replaced.

---

Recalls Number (Vehicles Effected)

R/2004/151 (3513)

Manufacturer Reference

oaf6

Defect

It has been established that in certain cases the tightness of the steering wheel mounting may not be to specification.

Remedy

Likely to be affected vehicles will be recalled at which time as a preventative measure the steering wheel will be replaced and it's mounting strengthened.

---

Recalls Number (Vehicles Effected)

R/2002/083 (1861)

Manufacturer Reference

0A8F

Defect

The engine may stall at idle and/or when lifting off the throttle following a period of hard acceleration.

Remedy

Check the serial number on the fuel pressure regulator and replace it if it is within the affected range.

---

Recalls Number (Vehicles Effected)

R/1997/010 (12500)

Manufacturer Reference

Defect

Wear in the area of the support bearings may lead to failure of the primary steering shaft and cause loss of directional control.

Remedy

The affected vehicles are being recalled to have the original shaft replaced with a complete assembly.