Date From | Date To | Concern |
---|
21/09/18 | | Raised: 19/11/19 - NOx SENSOR WAS NOT CORRECTLY TIGHTENED DURING MANUFACTURE View/hide..
Recalls Number (Vehicles Effected)R/2019/370 (116)
Manufacturer Reference0D6E
DefectNOx sensor was not correctly tightened during manufacture on the production line
RemedyTighten the NOx sensor to 32 Nm
|
20/09/16 | | Raised: 01/09/17 - SIDE AIR CURTAIN MAY NOT DEPLOY View/hide..
Recalls Number (Vehicles Effected)R/2017/172 (610)
Manufacturer ReferenceOCHZ
DefectThe curtain airbag (one or both side) may not deploy in the event of a side impact because the pyrotechnic mix ratio in the ignitor could be incorrect..
RemedyRecall the vehicles that are likely to be affected and check the serial number of the curtain airbag. Replace airbag if required.
|
| | Raised: 04/11/16 - REAR BOLTS ON FRONT SEAT RUNNER MAY NOT BE TORQUED CORRECTLY View/hide..
Recalls Number (Vehicles Effected)R/2016/199 (217)
Manufacturer ReferenceOC9E
DefectThe bolts that hold the front seats to the floor may not be correctly tightened. This may cause the seat to become insecure and control of the vehicle to be compromised. Prior to failure there will be increased movement of the seat when getting in and out of the vehicle which should be noticeable to the driver.
RemedyRecall the vehicles that are likely to be affected to check and where necessary adjust the torque tightening of the rear bolts on the front seat runners.
|
| | Raised: 08/01/16 - ENGINE POWER AND/OR BRAKING EFFICIENCY MAY BE AFFECTED View/hide..
Recalls Number (Vehicles Effected)R/2016/001 (527)
Manufacturer Reference0C68
DefectOn affected vehicles the drive to brake vacuum pump may fail. This may cause a loss of brake servo assistance and a hard brake pedal. It may also cause a reduction in engine power.
RemedyCheck the manufacture date of the vacuum pump and where necessary replace the pump.
|
01/09/03 | | Raised: 02/06/10 - UNEXPECTED APPLICATION OF PARKING BRAKE View/hide..
Recalls Number (Vehicles Effected)R/2010/050 (66735)
Manufacturer ReferenceOB7K
DefectThe parking brake may apply without input from the driver as a result of a programming error.
RemedyRecall the vehicles that are likely to be affected to check and where necessary reprogramme the electronic parking brake computer.
|
01/01/06 | | Raised: 27/10/09 - POSSIBLE LOSS OF POWER ASSISTANCE TO THE STEERING View/hide..
Recalls Number (Vehicles Effected)R/2009/116 (34403)
Manufacturer ReferenceOB1E
DefectPower assistance to the steering might be lost because of a problem in the software.
RemedyRecall the vehicles that are likely to be affected to reprogramme the ECU.
|
01/08/03 | | Raised: 31/10/06 - FRONT SEATS MAY NOT LOCK INTO POSITION View/hide..
Recalls Number (Vehicles Effected)R/2006/177 (5354)
Manufacturer Referenceoark
DefectThere is a possibility that the seat back of the front seats may become difficult to adjust and or not lock into position.
RemedyRecall the vehicles that are likely to be affected to check that all welding to the seat back frame is present. If the welds are not all present then the seat back frame will be replaced.
|
01/09/03 | | Raised: 12/06/06 - BRAKES MAY FAIL View/hide..
Recalls Number (Vehicles Effected)R/2006/078 (57995)
Manufacturer ReferenceOANY
DefectIt has been identified that the possibility exists that the stop for the foot brake pedal collapse system is missing. This can result in the loss of braking efficiency when the brake pedal is at full travel.
RemedyRecalled vehicles will be inspected for the presence of the brake pedal collapse system stop and where this is found to be missing the brake pedal will be replaced.
|
01/02/03 | | Raised: 08/05/06 - SEAT BELT STALK MAY DETACH View/hide..
Recalls Number (Vehicles Effected)R/2006/045 (93289)
Manufacturer Reference
DefectIt is possible under certain conditions for the seatbelt stalk fixings on the first row of rear seats to become loose.
RemedyRecall the vehicles that are likely to be affected to remove the bolts retaining the stalks of the affected seatbelts. Thread adhesive is to be applied to the bolts then the bolts are to be refitted and torqued.
|
05/12/99 | | Raised: 15/02/02 - POSSIBLE LOSS OF BRAKE POWER ASSISTANCE View/hide..
Recalls Number (Vehicles Effected)R/2001/162 (11960)
Manufacturer Reference0A4H
DefectNon air conditioned Megane and Scenics equipped with K4J or K4M engines with a pre-catalytic convertor fitted may have a hard brake pedal (lack of braking assistance). This is caused by the deterioration of the braking assistance pipe as it passes too close to the source of heat emitted by the pre-catalytic convertor.
RemedyRecall affected vehicles and replace and/or reroute the brake assistance (vacuum) pipe.
|
| | Raised: 15/02/02 - ENGINE HESITATION AND IDLING CONCERN View/hide..
Recalls Number (Vehicles Effected)R/2001/159 (1574)
Manufacturer Reference0A4Z
DefectVehicles fitted with 1.4 16v engines and having the MGI motorised throttle housing and Sirius 34 injection computer may have engine hesitation and idling speed instability. This due to incorrect locking of the connector to the throttle housing causing instability in the operation of the injection system.
RemedyRectified by replacing the motorised throttle housing connector.
|
01/06/01 | | Raised: 10/01/02 - FRONT STABILISER BAR BRACKETS CONCERN View/hide..
Recalls Number (Vehicles Effected)R/2001/160 (205)
Manufacturer Reference0A56
DefectThe front suspension stabiliser bar brackets may fracture.
RemedyReplace both front stabiliser bar brackets.
|
| | Raised: 14/12/01 - POTENTIAL FUEL LEAKS View/hide..
Recalls Number (Vehicles Effected)R/2001/138 (3586)
Manufacturer Reference0A3E
DefectThere is a risk of the diesel return pipe rubbing against the alternator and there is a risk of leakage from the connections of the high pressure pipes to the injectors. It is possible that the high pressure pump supply pipe may wear against the acoustic protector.
RemedyReposition or replace any chafing fuel pipes as appropriate. Check the union connections for correct tightness on the high pressure pipes to the injectors.
|
01/02/00 | | Raised: 18/04/00 - POSSIBILITY OF REDUCTION IN VACUUM SERVO ASSISTANCE View/hide..
Recalls Number (Vehicles Effected)R/2000/044 (10425)
Manufacturer Reference0094
DefectA specific batch of vacuum pumps may have a potential defect (blockage) which may cause a reduction in servo assistance.
RemedyRecall affected vehicles and replace vacuum pump.
|
01/06/97 | | Raised: 12/06/98 - FAILURE OF ROOF BARS View/hide..
Recalls Number (Vehicles Effected)R/1998/022 (4000)
Manufacturer Reference
DefectThe roof bars may fail when loaded to the limit of their carrying capacity. Failure could result in loss of luggage.
RemedyAffected vehicles are being recalled to have the original roof bars replaced with quality assured examples.
|
01/07/97 | | Raised: 30/10/97 - POSSIBLE RESTRICTION IN HYDRAULIC BRAKING SYSTEM View/hide..
Recalls Number (Vehicles Effected)R/1997/073 (7434)
Manufacturer Reference
DefectThere is a possibility of a restriction in a plastic double pipe union on the brake master cylinder. This could prevent or reduce the operation of the hydraulic braking circuit.
RemedyAffected vehicles are being recalled to have the plastic union examined for evidence of any restriction. If a restriction is found the plastic pipe union will be replaced with a quality assured version.
|