SUZUKI JIMNY UK Recall Check

---

Recalls Number (Vehicles Effected)

R/2021/173 (2321)

Manufacturer Reference

R21/07

Defect

Improper design of the driver side and the passenger side door harnesses may affect air bag operation..

Remedy

Replace the door harnesses of the affected vehicles.

---

Recalls Number (Vehicles Effected)

R/2021/172 (510)

Manufacturer Reference

R21/06

Defect

The fuel feeding impeller in the fuel pump may be swollen and deformed.

Remedy

Replace fuel pump.

---

Recalls Number (Vehicles Effected)

R/2016/211 (447)

Manufacturer Reference

R16/09

Defect

The brake servo booster may not have been correctly manufactured. This may cause a harder feel to the brake pedal operation and require more effort from the driver.

Remedy

Replace Brake Servo Booster on affected vehicles.

---

Recalls Number (Vehicles Effected)

R/2015/163 (170)

Manufacturer Reference

R15/11

Defect

Small resin fragments may have been left in the Electronic Stability Control unit during production. These fragments may cause the ESC valves to stick and delay operation of the ABS/ESC systems.

Remedy

Replace the ESC unit.

---

Recalls Number (Vehicles Effected)

R/2014/061 (1510)

Manufacturer Reference

R14/--

Defect

A bolt securing lateral rods to the front and rear axles may become loose and cause a vibration through the steering wheel. These rods act as an anti tramp measure. If the bolt wears it can drop out allowing the axle to tramp and cause the steering effort applied by the driver to reduce.

Remedy

Replace bolts on affected vehicles with modified version

---

Recalls Number (Vehicles Effected)

R/2010/067 (5425)

Manufacturer Reference

Defect

Steering assistance may be lost because the power steering tensioner pulley material is not to specification. The pulley may fail and cause a loss of drive to the hydraulic pump.

Remedy

Recall the vehicles that are likely to be affected to inspect and where necessary replace the power steering tensioner pulley.

---

Recalls Number (Vehicles Effected)

R/2001/126 (3814)

Manufacturer Reference

R01/11 &R01/12

Defect

The bolt securing the gear selector yoke to the gear selector shaft may loosen and fall out. This will allow the gear selector yoke to become detached from the selector shaft. In this event it will not be possible to select gear.

Remedy

Fit a higher tensile bolt to the gear selector yoke and tighten it to a higher torque specification.