Car Recall Check

An insufficient amount of bearing grease might have been applied to the needle-bearings in the rear hub housing (roller bearings), during the manufacturing process. Consequently, the bearings might become damaged, leading to the blockage of the rear wheel while the vehicle is in motion, increasing the risk of an accident.

The fuel hose may have been manufactured using a resin-based extrusion mandrel that was larger than design specification, thus it may have an improperly loose connection with the metal fuel hose connection pipe. As a result, fuel may leak at the joining point, increasing the risk of fire. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of two- or three-wheel vehicles and quadricycles

The fuel hose may have been manufactured using a resin-based extrusion mandrel that was larger than design specification, thus it may have an improperly loose connection with the metal fuel hose connection pipe. As a result, fuel may leak at the joining point, increasing the risk of fire. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of two- or three-wheel vehicles and quadricycles

The fuel hose may have been manufactured using a resin-based extrusion mandrel that was larger than design specification, thus it may have an improperly loose connection with the metal fuel hose connection pipe. As a result, fuel may leak at the joining point, increasing the risk of fire. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of two- or three-wheel vehicles and quadricycles

The plastic plug on the carbon filter drain hose may melt by the heat emanating from the exhaust and act as an ignition source. Consequently, small quantities of fuel may escape through the open/damaged plug and melting plastic can drip onto the exhaust manifold, increasing the risk of fire. The product does not meet the requirements of the General Product Safety Directive.

The plastic plug on the carbon filter drain hose may melt by the heat emanating from the exhaust and act as an ignition source. Consequently, small quantities of fuel may escape through the open/damaged plug and melting plastic can drip onto the exhaust manifold, increasing the risk of fire. The product does not meet the requirements of the General Product Safety Directive.

The plastic plug on the carbon filter drain hose may melt by the heat emanating from the exhaust and act as an ignition source. Consequently, small quantities of fuel may escape through the open/damaged plug and melting plastic can drip onto the exhaust manifold, increasing the risk of fire. The product does not meet the requirements of the General Product Safety Directive.

Due to discrepancies in the assembly process, there may be a misalignment between the gear teeth on the licence-plate holder and the swing arm. This may lead to the licence-plate holder being twisted and may subsequently cause the collar nut on the rear wheel spindle to loosen.As a result, the licence-plate holder may become detached, leading to increased risk of an accident. The product does not meet the requirements of the General Product Safety Directive.

Due to discrepancies in the assembly process, there may be a misalignment between the gear teeth on the licence-plate holder and the swing arm. This may lead to the licence-plate holder being twisted and may subsequently cause the collar nut on the rear wheel spindle to loosen.As a result, the licence-plate holder may become detached, leading to increased risk of an accident. The product does not meet the requirements of the General Product Safety Directive.

The gear-selector drum may be defective and could break.This could result in consequential damage to the transmission and in locking of the rear wheel, increasing the risk of an accident. The product does not meet the requirements of the General Product Safety Directive.

The gear-selector drum may be defective and could break.This could result in consequential damage to the transmission and in locking of the rear wheel, increasing the risk of an accident. The product does not meet the requirements of the General Product Safety Directive.

Due to the shape and mounting position of the motorcycles’ front fuel tanks, occasional abrasion may occur on both fuel lines. This could result in a fuel leakage, increasing the risk of fire.